Mitz port
Procedure: *** This lab has to be implemented only in hardware (using NI myDAQ) *** Analyze the circuit in the Figure 1 below to calculate the following values: VE, IE, VRC, VC, VCE. Make sure to include 20% tolerance for each resistor in the calculations. Construct the circuit shown in Figure 1 below on the breadboard using the transistor and two resistors (RCand RE). Using the jumper wires, screw driver and screw terminal connector, connect the board to NI MyDAQ Instrument Device. Use channel +15V pin out on the NI myDAQ Instrument Device to provide the supply voltage (VCC) and channel AO0 to provide the base voltage (VBB). Make sure that this voltage is peak-to-peak. Use channel AI0 to measure the required voltages using the oscilloscope.